just viewed your imagined dilemma - the jade colour of doors - are they a laminate - if they aren't - yes if you desperately need a change - have white laminate (like the whole neighbourhood). but if the jade cupboards are definitely laminated I would not replace - for the jade is stunning. Furthermore, you would make a good move to extend the black high-gloss laminate to those floor-level cupboard doors which currently have a wood strip (which the previous owner did (I presume)I would suggest you have a single black strip definitely 2inches high inserted as a line in that area. (this job must be done by an experienced laminator - to perfection (this will eliminate the eye-sore strips of wood.( but it must be applied as a continuous band (from a to b) - not bits - Furthermore, the high-gloss black floor-boards will look good so close - meeting each other. I NOTE YOU WOULD DO WELL WITH A LARGISH SLEEK KITCHEN SINK ( YOU SEE BY DOING THESE SMALL CHANGES YOU ARE GETTING A WHOW KITCHEN. Am I imagining the green which seems to extend to the ceiling line is not cupboards up there if that is so do not take the green up to the cornice - the cupboards are the feature not the walls - the cornice in that room should be taken out - having the plastered wall reaching the ceiling without cornice. Your kitchen cupboards are the feature.(it would be good to paint upper walls and ceiling. Just "off white" I am reluctant to tell you the kitchen window should be wider as the kitchen has a message but the window is like a poor relative. If you carry-out these changes - the kitchen should be free of everything else - no utensils on the stove, nothing on benches or on top of other areas - the colour and impact - that is all that is needed (plus it has become modernised) - despite your belief that white is in - maybe in hospitals. Good Luck

Hi I just thought I would leave a comment about the visibility of joins in reconstituted stone such as Caesarstone tops on islands longer than 3 metres. From a patern point of view; by selecting a style that has a fine grain certainly helps with reducing the visibility of a join. As for the join itself, the technology and tooling used to make such joints has come a long way in the last 10 years; therefore if you use a Kitchen Manufacturer who uses up-to-date stone fabrication methods, then such joins can be next to near invisible. Below is a kitchen we made with an Island that is over 4.3 metres long and has a join through the centre; where the join actually has to be pointed out to be seen. We have seen Kitchen Manufactures use the two height method but you really don't have to do this to achieve a long island. If you would like a long island, then you should not be put off by having to have a join; careful selection of your material, manufacturer and planning can achieve great results. Hope this helps anyone reading this article and the comments above.

Cheapest thing to do would be to paint the doors put a bit of timber benchtop from Bunnings and perhaps mirror the back panel, but where's the Bar Fridge going or are you planning a bigger fridge nest to this. As Louie suggested it might be better to get rid of the old as there's no place for a much needed Bar Fridge, A Barn door of whatever style suits you would work well, you can pick up second hand doors with character for this. Then again some Bunnings timber benchtop , (Mel) fitted & supported by beams screwed into the rear and sides of the nook and hidden by a strip across the front as your bench top. With a bar fridge under this, floating shelves above on the wall for bottles /glasses and DVD player etc, much easier to use the DVD when it's not in a cupboard love the room.

keep the big rangehood, it will do a better job and look better, but try and have it centred over the cooktop