Modern rustic: 12x24" porcelain tile made to resemble a wide piece of distressed wood. Not an overtly obvious wood grain, more of an implied grain that you only see after studying it for a minute. Rectified and small grout joint. (Form follows function in design- easy to live with is always first!) option B: a vein cut travertine patterned 12x24 in brown or gray tones. Set in a soldier corse, straight stack pattern, so it's not about the grout joints, it's more about the linear pattern of the tile.

I like the top right picture where the grey floor tile appears to run up the wall. But the floor tile looks lighter than the wall, is it a different tile? I would pick a lighter shade from the Kalala Shan as the 2nd tile. Does the tile shop have a contrasting colour from the same family of tiles? Not sure I would go 2 different textures, unless one was really flat and non descript to contrast with textured one that would be the stand out feature. Great colour choices though. And would look lovely coming off the spotted gum floors too!

Since this thread started I've moved house and renovated two more bathrooms and this "step" issue is definitely becoming a headache. You know, we are such slavish followers of trends, I just have to wonder at times how much we are becoming victims of them too. When I built my first house over 50 years ago, most homes were built on piers with timber flooring and concrete was only used in bathrooms and laundries, but the levels were adjusted so when tiles were laid in wet areas the transition was minimal. Floor tiles were also thinner than today's tiles, in most cases they were smaller tiles too and not these great slabs we use today that obviously need to be thicker for strength. Now we are building more slab on ground homes, no provision is being made for the thickness of floor tiles to ensure a more seamless transition between areas. My front entrance is tiled and has a 2cm "step" down to the lounge and family room areas and even that 2cm I find people constantly tripping over. I plan on removing these tiles and replacing the whole entry/kitchen/family area with vinyl planking. Carpet in the lounge room helps offset that step a little but I was told recently by people who have addressed this issue this way that putting an extra layer of underfelt within the doorway area works very well to help offset this problem. When I renovated the ensuite I now have this step issue but the tiles had been glued down with an unknown product of super strength that gave my bathroom guy a lot of grief trying to jackhammer up - took him 2 days to remove them and screed the floor to his standard - and he decided he could not do the main bathroom in a realistic time frame to meet the price he quoted me, he felt he could not even guarantee the standard of work he wanted to achieve so his suggestion was to tile over the existing tiles and when he got to the doorway he would add an extra part tile sloping to down to the floor level similar to what pucciplan described with his timber. He assured me he had done it with many other renovations, it was barely noticeable and would solve the issue much easier and cheaper for me and far less time consuming. In the meantime as I have carpet in the hallway we heard of the idea of using an extra layer of underlay and I've chosen this option. My laundry is right opposite the bathroom and those tiles will be replaced too. On close inspection of the original construction, we discovered no waste drain was put into the laundry, the tiles were drained towards the external door, which is apparantly acceptable .............EXCEPT, they then put a dam across the floor inside the doorway to stop rainwater coming in under the external door!!!! Now the laundry tiles will be laid over the top of the existing ones as well to allow for any possible accident needing drainage. Fortunately I've had no weather issues but we will put a rubber flap at the base of the door, just in case, and I will again do the extra layer of underlay under the carpet and hopefully will achieve a satisfactory result. At least the two doorways will match. Quite frankly though, I'm finding so many design issues these days, I really think the whole home building industry needs a thorough overhaul. I think as I age too, so many more issues are coming to light BUT they are obviously issues that could affect anyone of any age. I think we need to forget "trends" that don't consider the big picture of things and come back down to basic commonsense. HU - I'm really at a loss as to how your builder managed to get a 6.5cm step to the bathroom, that is absolutely ridiculous. The only thing I can think of is there may have been a slope issue for drainage, but surely it could still not have been that much, anything that much out should have been picked up when the building was inspected during construction. "Normal" is a good excuse for laziness or shoddy workmanship. I think from reading your posts, you are in an apartment?? You would then have slab floors?? Therefore I can't see the need for the step to be above 2cm. Definitely take this further - Fair Trading should be able to help you, the standard heights for steps varies according to location and use - it is a bit of a minefield to work out. Good luck. Amanda - how did all your renos go in the end? Sounds like you are still sane. :)

Hi Kirsty, could you please advise the colour of your vanity and whether it is a custom made one and if not, could you let me know its name and where you bought it. Also, what is the colour of your floors tiles and where did you get them from. (I have come to the conclusion that charcoal/dark grey tile plus a much lighter grey tile plus white on some walls plus a timber vanity or timber accessories in bathroom , plus white (or close to it) below sink counter top is the way to go for a beautiful bathroom. The trick is figuring out exactly what proportion of each colour to use and where to put them for each particular layout.