I think it is because if the tap handle doesn’t overhang the sink then wet hands drip water over the bench behind the sink. I have an undermount sink with same issue due to required setback from sink and we are learning to shake hands before turning off tap. Pro for wall mount no gunk around base of tap Negative according to my husband who refused to have wall mounted is the tap connections are in wall so if you get any leaks it’s hard to fix. But this goes same for shower I guess. We did have a faulty basin tap that leaked inside the handle area and down into cabinet so had to get replaced so I didn’t-push for wall mounted again.

I had the same dilemma and after many suggestions found that 90cm from the ground to the bottom of the tv was most recommended. It is a perfect height for our 60inch at both sitting level and standing.

Hi Dr Retro, Thank you. I really appreciate the input and the time you've taken to explanation your point of view. I really do want to get an understanding of where the issues lie in this design. So I hope you'll forgive me digging a little deeper. I don't quite follow why you think the design would require a 6m lintel. Yes, it does require a 6m track, but the track can simply be attached to the wall. The weight of the door need not be supported by the top track. It could be supported from below. The whole point of putting the configuration on the outside of the wall is to minimize the need to make structural changes to the building. There currently is no capacity to install a 6m wide external sliding door/window unit. Likewise I don't follow why the door should be any draftier than any other external sliding doors. The cavity is on the outside of the wall, so draft is not going to get in via the cavity. Other sliding doors of the unit type have the same draft problems this configuration would and solve it by using an overlapping flange at the front end of the fixed door and the back end of the slider. The same could be applied here, where we treat the wall as the fixed door.The point at which the doors engage each other has also be solved for other door configurations. It is just a matter of having a loose tongue and groove configuration. Again this is exactly the same as a unit providing center opening sliding doors. Finally the same sliding mechanisms are used in other sliding door configurations, so I don't see why that should be any draftier here either.

Does anyone have any experience of a wall mounted cupboard, that the ironing board folds down? I have found a Robin Hood version, available from Bunnings, but am keen to see any to compare. Thank you in advance for any replies