Staircase!!
Sarah Louise
7 years ago
Featured Answer
Comments (23)
Morel Construction Ltd
7 years agoRelated Discussions
This or That: Carpeted or timber stairs?
Comments (78)My parents' old house had a wonderful oak front staircase that my six siblings and I used to race up and down, taking them two or three at a time, with only a casual hold on the railing. I don't know how we managed to never slip or fall. Now, the timber backstairs were steep, and had narrow treads and were poorly lit. We NEVER ran up or down them, but held tightly to the railing and hoped to heck we managed to stay upright. As an adult, my previous home had carpeted stairs, which I slipped on (wearing socks) and fell down twice, though thankfully I was closer to the bottom than the top. My current home has timber stairs with three narrow stainless steel runners stood on edge and inset horizontally across the front of each tread (this is supposed to help reduce risk of slips). I doubt I will get over the anxiety of taking another tumble, so I never go down them wearing socks, and if barefoot, I hold onto the railing for dear life and take it nice and slow. So far so good....See Morestaircase runner carpet
Comments (11)Tsar specialises in custom carpet and therefore we do a lot of stair runners, both contemporary and classical designs. We are Melbourne based and will look after you. We tend not to show too many of our uber-classical designs online, as these are less popular, but we have done a lot of them. Contact Tsar at 03 9252 0488....See MoreStair safety (toddlers)
Comments (6)May I suggest that you look up the NCC Volume 2 which specifies the safety design parameters for stairs and balustrades. Any new work done on stairs and balustrades must comply with the code. You need to look up sections 3.9.1 and 3.9.2 In summary, whatever method you look to you can't be able to pass a 125mm sphere through any part of the stair or balustrade. It also specifies the design parameters for wire balustrades to achieve the 125mm sphere rule. The design challenges for stairs are significant if you want the open back tread look. The easiest way is to install a block on the underside of the tread level with the back edge of the tread below. This way you can still have an open tread and achieve compliance. The harder problem occurs when using a wire balustrade and the resolving the gap that occurs between the treads and the lowest wire. I have seen several installations of late where the 125mm rule was very clearly not achieved. One was a very recent build and I'm still not sure how it passed the final inspection. The images from Miami Stainless show how this can be achieved. Clearly the best and most secure is the glass balustrade and the vertical bar balustrade. Good luck!...See MoreRecently completed stair project before and after
Comments (6)Thank you for your Comments. It was the under-coat primer we used. And the client opted to paint it Black eventually in his spare time....See MoreSarah Louise
7 years agoSarah Louise
7 years agoSarah Louise
7 years agooklouise
7 years agolast modified: 7 years agoSarah Louise
7 years agooklouise
7 years agolast modified: 7 years agoVy
7 years agolast modified: 7 years agoVy
7 years agolast modified: 7 years agoUser
7 years agoMorel Construction Ltd
7 years agoSarah Louise
7 years agoSarah Louise
7 years agoSarah Louise
7 years agoMorel Construction Ltd
7 years agoSarah Louise
7 years agoSammy Elder
7 years agoSarah Louise
7 years agoMorel Construction Ltd
7 years agoSarah Louise
7 years agoMorel Construction Ltd
7 years agoSarah Louise
7 years ago
Sponsored
oklouise