Hi chittering5 we used the 25.5cm lights. Our island bench is fairly small at approx 1800x900mm. I actually purchased 3 (at much better price than currently listed) but felt it was too many for the space when I mocked up the (widest) diameter of the lights with paper cut-outs. Trying to decide if I can use the 3rd light in the bathroom or something without it looking lonely....

This explanation may help, Source: https://www.renovatorstore.com.au/blog/lighting-and-power-in-your-bathroom-the-simple-rules-to-be-safe/ REQUIREMENTS Zone 0: Inside the bath or shower. Any Lighting used here must have a minimum rating of IP67 (protected against immersion in water) Zone 1: Above the bath or shower to a height of 2.25m. A minimum rating of IP44 is required Zone 2: The area stretching to 0.6m outside the bath or shower and above the bath or shower if over 2.25m. An IP rating of at least IP44 is required Outside Zone: Anywhere outside zones 0, 1 & 2. Where water jets are not to be used for cleaning purposes, the general rules of BS7671 apply In addition to the above, if there is a likelihood of water jets being used for cleaning purpose in zones 1 and 2 a fitting rated a minimum IP65 must be used. Now that this has been explained, always make sure to purchase bathroom lighting according to these standards to make sure that your bathroom is always safe. You should also have this principle applied when you purchase other electrical devices such as heated towel rails, or a guide to where you'd put sockets in your bath for razors and other devices. This may also fix the common misconception that LED lights are not rated for bathrooms. Typical LED lights have an IP rating of IP66 which is more than the needed IP rating standard that bathrooms should have. - Not to mention you'd be saving a whole lot from energy bills in the long run.

It might be worth while to consider the rest of the space also. Your breakfast bar/kitchen is located quiet closely to your dining table so depending on your kitchen space (apologies, I can't see too much of your kitchen from the photo) you might want to think about the overall style you want to achieve for you entire open plan space, and select pendants that would work for both your kitchen and dining. This is a project I worked on recently that shows how two different types of pendants can work harmoniously in the one space that is most similar to your kitchen and dining set up. Keep us posted on what you decide!

Couple of things to consider..... 1. With any lights above a stainless steel sink, the reflection appears on the ceiling, I don’t like it so I installed a black sink. I added very minimal pendant lights, basically they are spotlights on a stick but they can be dimmed. Also I placed mine off centre. Saying that, spotlights can also be dimmed and sometimes, less is more. 2.Pendants in the bedroom can be quite tricky.. Example...they have to be the perfect height, width and as far as a reading light, they’re not adjustable. They cost more as they need to be installed. If you don’t like them, you need to get an electrician to change them. I originally wanted pendants but opted for lamps, happy I did as my bed couldn’t quite be centred so it would have been a mistake. Good luck, hope this helps.