Hi Sofia I definitely think brick lay would work better on the walls in the bathroom purely because you have a 30x30 on the floor and a 30x60 on the wall. You will find the tiles could look out of place trying to stack them. It would be a different matter if they did not share 1 or more dimension. Perhaps in the ensuite, consider doing something like this: [https://www.houzz.com.au/photos/what-architecture-beirutful-house-eclectic-patio-london-phvw-vp~14310278[(https://www.houzz.com.au/photos/what-architecture-beirutful-house-eclectic-patio-london-phvw-vp~14310278) Tile the floor and half way up the back wall with the "floor tiles", perhaps a tile or 2 above the vanity unit and then continue with the white tiles to the ceiling. You could hang your mirror so it covered about 1/4 of the "floor tile" and 3/4 of the white above the centre of the sink. In the main bathroom consider something like this: [https://www.houzz.com.au/photos/victorian-dream-bathroom-victorian-bathroom-london-phvw-vp~39122647[(https://www.houzz.com.au/photos/victorian-dream-bathroom-victorian-bathroom-london-phvw-vp~39122647) Tiling the back wall to the shower in the "floor tile" to the ceiling with the white tiles behind the loo to the ceiling. Alternatively, tiling the entire back wall with the "floor tiles". The first option may make the bathroom feel smaller if the shower takes up more than 1/3 of the back wall. Doing the two different options would give the bathrooms continuity, but also some individuality. I hope this helps. Look forward to perhaps seeing the outcome. James

Nup, a good tiling job requires a good substrate. The best tiler in the world can't make a bad substrate look clean and good. No point on spending money on new tiles and a good tiler over an inferior base. Rip it all down, start again and get it right before tiling. Best of luck, Dr Retro Of Dr Retro House Calls

Sorry about what happened to you Niamh. Those tiles look lovely when done right. I hope you can get it resolved somehow. "Whatever you do don't get the same person back to do it again, (even if you hadn't paid them) Biggest tip I can give to renovators is if the trade hasn't cut it on the first run then you're pushing it uphill to try and get it over the satisfactory line. Better to cut your losses and pay to get it done by more experienced tradesperson, more often at a higher cost." Paul Di Stefano Design, I wish the internet had been around to give me that valuable bit of advice many years ago.

Yes I have by Precious Tiling. For my home, we first did the concrete flooring then laid the vinyl tiles. For a quality job, the substrate must be clean, flat, and very smooth. To fit tile around pipes or obstacles, cut a pattern from cardboard and then use a contour gauge or compass to transfer the pattern onto a tile.