Thank you all. I spoke to Blanco again today and they said they don't make a 3 hole sink - it is up to our plumber to put a hole in. So risky!!! Final option is to look at putting it in the bench as 10design suggested...otherwise I think I'll just forget about the soap :( Would rather that then stuff the sink

Re the asbestos thing (and don't take this as pro advice...cos I aint) but if it looks like, quacks like it then it MIGHT be it. I thought I had asbestos walls (cos everyone said "it might be asbestos"...similar to some kid who may have been Jake Gyllenall saying to Arnie "it might be a toomore"). My walls were not asbestos. However I did find out that you can remove a certain square meterage of asbestos (depending on state boundaries) without have expert (very expensive) assistance (check the state rules). If it "might be" then be careful. As you are tiling over (therefor not cutting, grinding, messing about with?) then stay cool and tile to your tile glue's content!

Hi, This is totally normal. To answer your question, the location of the taps depends on the sink. If the sink has a landing (space for a tap hole) you can elect to obtain it with or without the hole/s and have the tap on either the sink itself or the benchtop. If as in the case of the Franke one you've selected, there is no landing then the taps are mounted on the stone. The cabinetmaker usually provides a template of the benchtop when the carcasses are installed for the stone supplier. This is then used by the stone supplier to make the correct size and cut outs for eg the sink. They will want the sink so that they can do the cutout to suit. They either then drill the holes for the tap/s during production or do it on site. It's no biggie. You just need to have the tap selected so they know what size holes to drill and where you want them. Take care to keep in mind clearances between the sink bowl and the cupboard carcass or other items. It's usually tight. We always plot the location of the taps while we have the template on site so we can check clearances etc. Cheers

Could you do a sketch of the space, with measurements. what are the measurements of the total area, including the internal measurements of the double door cupboard. Am i looking at your pictures correctly.. Is this an internal room with no door to the outside? Why don't you want a sink in the laundry?