Check out this story from Houzz - I commented that I used to worry about mixing too many woods until I read the article.. http://houzz.com.au/sr/m=7/u=L2lkZWFib29rcy81NjI5NTA4NQ==

We're doing the same, 2 sets. Want wood but have been told they "may" warp, even though under a covered alfresco. Don't have a firm cost yet but indication from builder is $10-15k more than powder coated aluminium. Total width of each set is 3250 divided into 3 doors, with stacking security screens. Don't have a price for the aluminium ones yet to compare but +$10-15k has probably helped with the decision. Have bifolds at current house but will be going for stackers at the reno house because they can have the stacking security screens, whereas bifolds are difficult to security screen, you can flyscreen but it's quite a flimsy arrangement.

Hi Kruti. Those new pieces are lovely. There’s a houzz article in Stories about how to decorate a console table. If you select Stories, then Interior Design, then Decorating, and then type ‘how to decorate a console table,’ in the window, the article should pop up. I think you will find it very helpful.

Don't go with white. While it is easy to replace door fronts and drawer fronts you won't be able to replace the tall vertical panels adjacent to the fridge recess and the microwave recess without pulling out half of your cabinetwork. If you went with a white you wouldn't be able to match the same white as these vertical panels, and the new white would look off next to the old white or vice versa! I'm afraid there is no easy solution that will make the new doors blend in with the old vertical panels, so I would go with a bold contrast colour block that looks good with the white vertical panels, as well as the black granite. Perhaps consider a Piet Mondrian inspired kitchen facelift, by introducing some black edging to the vertical cabinets and a careful composition of blocks of primary colours? Best of luck, Dr Retro of Dr Retro House Calls/Dr Retro Virtual Visits