Hi fivedock No problems. I have tweaked it a little in response to the other rooms. The kitchen lights are moved out slightly off the cabinetry for better overhead lighting and added two under cabinet /bulkhead lights that are wall switched. Have also added a light for just outside the laundry for when you are standing there with washing. Back room can be on one circuit although I have shown two as don't know where you are placing furniture. We make the bathroom lights separate as shown and also do the fan separate. Our sparkie hates it but we like to be able to use the room without the fan automatically coming on. Have shown pendants in the master but that's up to you. I can delete if you like. On a side note, are the bedroom doors swinging that way deliberately? We would normally swing them opposite to that shown so that they open against a wall and you have clearance to walk around the beds. If this is to be changed then your switch locations need to be changed also. Cheers

Hi , I did a major repaint of my kitchen when I moved in last year (this is the second time I've done this in a home). From salmon pink doors and tiles with plastic pink handles, it has transformed into quite a lovely kitchen with crisp white benchtops and doors, retro aqua blue splashback tiles and chrome hardware. I didn't paint the floor tiles because it is not a good idea, it won't last. And I think in your case, the kitchen floor will not look as bad when you take care of the cabinetry and countertops (and appliances - don't forget the sink, this made a huge difference to my kitchen which had a horrible stained "white" fibreglass sink and plain tap). The only regret I have is that I was convinced instore by a staff member to use water-based enamel on the countertops and this was not a good idea as it marks and stains at a feather's touch and I am always scrubbing it with magic erasers to bring it back to white. Just use oil-based enamel, preferably gloss, and it will clean up beautifully. It will just yellow in about 5 years' time, which isn't an issue if you're not using crisp white like me. Step 1: remove all handles etc. and sand back the melamine/formica surfaces and vacuum up all dust. Wipe down all surfaces with methylated spirits to remove any other dirt and - especially - oils. Step 2: Undercoat all surfaces with White Knight Grip Lock Primer (keep this stuff on hand, it is magic and can be used for a million things). Give it two coats preferably. Step 3: Paint doors and cabinetry with a good quality high gloss acryclic. You can use oil-based enamel too, but it's easier to work with acrylic. It doesn't really scratch unless the cat tries to jump up above the cabinets and claw its way back down when it misses - in other words, don't run knives or screwdrivers down the doors and they'll be good. If it scratches, get a small artists brush and touch up with your leftover paint in the tins. It takes two seconds and is as easy as to do. Step 4: paint the countertops with an oil-based enamel. Clean up with turps. Do two coats and use a good quality brush. Give it a good few days to dry, a week is good if you have the time as it hardens in this time and becomes very strong - so put your camping gear and laundry sink to good use during this time! Step 5: put on new handles and hardware, install new sink and appliances and enjoy the makeover. For the tile splashback, follow the same steps, making sure you give them a good sand. You can use gloss acrylic here too. It will scratch if you knock it with a sharp object, but again, keep the touch up paints and a small artists brush handy. In your case, because the splashback doesn't go all the way up, I'd also consider chiselling the tiles out out and using a panelled splashback from somewhere like Ikea or Bunnings or a store that orders Laminex panels. They can be pretty cheap, and although not perfectly beautiful are a lot more attractive than those tiles. If you can save the tiles (the tile glue is probably old and brittle) and sell them, someone will love them on ebay! And even re-tiling with some cheap/chuck out tiles isn't difficult or expensive in that space if you are at all handy. Splashbacks in burnt orange or red would blend with the cream and floors. Other alternatives for the countertop (particularly if you don't want to patch up the gaps from the older, larger stovetops and sink) is to put in an Ikea or Bunnings (or similar) cheaper benchtop. I have also tiled a benchtop before and this worked really well with the added benefit of being able to put hot pots straight onto the benchtop. Don't use low end wall tiles. Use a stronger tile so they don't crack. Again, with your oh so brown floors, if you stick to lighter colours for the cabinetry (eg. antique white or cream) and a more sandstone-ish colour for the benchtops (or match the cabinet colour to the benchtop so you don't have to paint it and set off with the coloured splashback), the floors won't look as bad. Also, you can put a floor runner along the length of the kitchen hallway (in front of the oven/fridge area) if everyone in the house is generally steady on their feet and don't tend to trip over everything and this will break up the brown beautifully and you will barely notice the tiles. All in all, it cost me about $200 for the paint and equipment plus handles, sink and big shower tap, but it has meant that I am delaying my kitchen reno for a number of years, as I really like the kitchen now and everyone comments on how great it looks. None of this is hard to do. As a female, I have no problems doing all this myself as long as I have the time from work. But my father was a painter for 40 years, so that's why I can get the scoop on the best paints etc. to use on these projects. Good luck! PS: Don't let anyone tell you to whack some fancy paint on the doors and it will be done in a jiffy - it will peel off. Sand and grip lock prime - this is essential if you want it to look good longer than a couple of months.

Hi Doug, looks great! regarding the floor my only suggestion would be to avoid the grout line down the centre as you have it. it is the first thing that draws your eye, and if you are going to the detail and expense you are then looking down is not what is going to show it off. From that I mean make it complementary to other things not competing.... eg a simple 1/3rd 2/3rd off set to break up the line and allow your ceiling feature to draw the eye. cheers

there is also a difference between ceramic and porcelain tiles - often these issues come down to a combination of (a) tile batch size/consistency (b) tiler's skill/capacity (c) communication in that if the tiler opens the tile box and he can't practically achieve what he thought he might because of the general discrepancies in size then they should at least speak to you before they start. So often with many issues in this game, it's about managing people's expectations and having open/honest discussions at the right time. When this breaks down, problems and disappointment is more likely to occur......so coming back to it, if you have high quality porcelain tiles that are millimetre perfect, square and flat then the capacity to lay them with minimal spacing is higher. Also the substrate/prep plays a part as if it's all out of whack and not perfectly straight/plumb/square then you'll be in all sorts trying to achieve the minimal tolerance detail.