We recently completed a survey on this very topic - and 30% of Americans say its the toilet tank! Options include going for a wall-mounted design that hides the tank (and saves space) or our Monolith toilet which replaces the bulky ceramic tank with sleek glass.

@Souzette Lovell, I know nothing about bidets but just commenting on your question about water being splashed on untiled areas of your bathroom. I constructed my bathroom entirely with villa board, and the only plaster is on the ceiling. I have also tiled the entire bathroom to the ceiling because it made sense to do this rather than be concerned about any water ingress anywhere as well as any damage from something like the hand held shattaff you mention and it means zero maintenence having to repaint from time to time. My suggestion is if it's not too late to use villaboard and not plaster, in fact I'm surprised all bathrooms aren't fitted out with villaboard but I don't think it's compulsory except for the shower cubicle. I did it so there would never be an issue with water damage as this material is impervious to water ingress. Otherwise if it's too late and your bathroom is complete, I would tile this wall or a section of the wall as it would make more sense to be able to wipe the tiles regularly in case of any unwanted splashes from regular use if there are children especially, as their aim isn't always perfect and it's hard to clean plaster ha-ha!!

Hi Mike and Emma Hope you are slowly but surely getting there... may I make some comments/suggestions that you may or not take on board, but hopefully it may at least give you some ideas/options... Going through a new build ourselves at the moment, and for what it's worth, here's what I personally think: A. Work with what you've got: - additional plumbing work, gas work etc may not be necessary and (particularly gas) can be costly when you're trying to work around existing walls, floors, etc, and as much as possible utilise the existing connections... after whatever you can save here and there, you can spend on nicer cabinetery, gadgets, finishes, etc :) B. Avoid unnecessry structural work: - removing the kitchen/living wall is a must (more space, light, etc) but removing the laundry wall is an unncessary added cost (may even require costly additional strutural support) - putting up a plastered wall on the other hand is inexpensive, allows you to redefine different zones and relocate doors/openings where required (*note: avoid hinged doors in small spaces as you have to allow for wasted space to open door - suggest cavity sliding doors, easy to incorporate in a new wall) C. Don't sacrifice functionality and natural light for design - love full height floor to ceiling cabinets, very much on trend... but they also tend to bring the walls in, which you want to avoid in an already small space... they will also block out more natural ligtht from the only window to the living and breakfast bench (meals area)... not to mention seated guests would be staring at a cabinet tower and fridge - on the other hand a walk in pantry (not that much of a walk in a small space) is also very much on trend, provides more storage and... as entertaining guests in open plan livings tends to happen more in the kitchen... it provides a good hiding place for unsightly items, including frigges... (an underbench bar fridge in the kitchen can easily keep those beers cold... though do consider that means sacrificing some cabinet space) - constantly wiping off the floors from dripping wet dishes across the kictchen from the sink to the dishwaser on the other side bench would personally drive me mad after a while... the dishwasher can easily be connected to the existing sink water and waste points through the cabinerty... any half decent plumber should be able to do that... ON THAT NOTE... or should I say those notes... I know I got a bit carried away :) ... if it were me, here's an idea of what I would try to achieve ...

Things are ticking along . We have a whole lot of long skinny flush-mounted LED taillights -- they won't be fitted until we take Frankie off the road to re-paint , as the existing lights come off , and these ones will need holes cut , the exterior repainted , then these lights bonded ( glued ) in . The Mercedes seats have had new certified mounts made ( being a safety item , we spent about $150 getting them certified -- keeps it legal , although there are literally thousands of vehicles out there that have had seats changed , and no certs ) and we made little 'boxes' that have walnut tops , and all the controls for the electric seats are in these ( on Merc cars , they are on the doors , but our auto sparky has made new mini wiring looms ) . We dropped the seats to the upholsterer last week , so in the next month or so they will be recovered -- a sort of bone/cream leather for the surrounds , and red leather with diamond stitching up the middles . This is almost what my cab looks like , mine has 1980's Falcon or similar bucket seats in a grey vinyl . I assume that was done so that there is only the 2 seats , and you can get through to the back , whereas in the pic with 3 seats , you can't . My interior is the same colours -- 3 different charcoal/grey tones on the dash , then a black on the doors ( why , I have no idea -- I would have thought charcoal would have been better ? ) . Once the seats are back and fitted , I am tempted to get the door cards redone -- do a padded charcoal vinyl that matches one of the dash colours , but do a 'scallop' from the rear of each door in the lighter leather , then a red maybe 150mm wide scallop in the middle . I feel that will tie in the doors , the dash and the seats better . The booth seating ( table and chairs basically ) in the rear will get done the same cream/bone and red leather , to tie it in a bit more . Which then brings up 1 problem . You may have noticed I have used a downloaded pic , and I was going to post a few 'before' pics of the cab and the rear , so you can see it in its 90's wooden and tacky lino glory , but that turns out to be a problem . All the 'before' pics I have are ones that the last owner e-mailed to me . I downloaded them all , they are still on my computer , I can look at them no problem . BUT for some reason , they aren't JPG's -- they show as 'Google Chrome Files' , and I can't work out if I can post them here -- I've tried but nothing happens . Are there any experts that know how to post these 'files' ( pictures ) ?