Hi Hu, In terms of shower placement - not necessarily. It can be where ever you wanted it and common sense will prevail. A consideration with the smart tile grates (dependent on which you use) sometimes they dont allow the water to escape fast enough. They have a tendency to sit low in the cradle and inhibit the water drainage. If the water is sitting around your feet the drainage point would seem to be in the right place. It could be a partially blocked drain and that can be myriad of reasons. There are silicon seals that clip on the door that will stop water (nearly always a problem with frame-less screens) escaping. But please talk to your Builder and get him/her to examine the problem. Ask your Builder to get the plumber back to check it out for you. I hope this is helpful. Cheers Trevor

Hi Paul, I hear your collective frustration! my comment about light bouncing into your eyes was in response to your question about bouncing light onto your faces from a light placed behind the vanity (from memory). Have you seen Dr Renos comment here - still the most logical response to me. https://www.houzz.com.au/discussions/5148857/where-to-place-power-points-and-lights#n=5 So I'm going to go for side lights next to the vanity cabinet. Trouble is, my vanity is off-centre to the cabinet mirror, so I still have to sort that one out. Time spent really considering this is well worth it. I think LED downlights may very well cast shadows, sorry to say :-) and the next consideration is what colour temperature - warm white or daylight? For relaxing ambience (75% bathroom function) it will def be 3000 warm white for me, however for the vanity functions it will be 4000K (daylight) so I will probably get the vanity lights switched separately to the main room light, maybe put that on a dimmer... I know there are some LED bulbs available that enable the colour temp to be changed within the same bulb...

Your renovations are well underway, so after seeing the small floor plan and that the vanity is on an internal wall and you apparently still want the Shaving Cabinet. Having cavity brick walls I would get your brickie to remove a section of the brick wall so that the shaving cabinet can be recessed back into the cavity, this will overcome any concerns you have about bumping your head, this opening can then be patched along with other walls. I would take all of your photos and measurements to someone like Reece to pick a hand basin to fit,, I would also keep in mind that if say the width of the vanity is around 900 the shaving cabinet would match that width and you would end up with say 2 x 450 mirrored doors, which puts the mirror join in the middle and in your face when using the vanity. cheers

Hi all, It's very difficult to find where I can get a decent quality glass bowl. The majority of the bowls which I suspect are chinese imports are tainted glass, where I am looking for a pure quality similar to the work that Euroglass undetakes. Does anybody know where I can buy one from?