This advice may not be of help but I had silicone all over glass bricks and when I read the destruction notes on the tube, it said use turps. I did use one of those razor blade scrapers as suggested in the previous post and it did help once the silicone softened up but I would be concerned about it scratching the floor in your case, albeit if you hold it right is shouldn't. I was dubious that the silicone could be removed having been there a few yeas on my glass bricks but it did work albeit it took allot or rubbing. Not sure what turps will do to the fresh polish but perhaps you could ask the maker of the silicone, as the tube info usually has a hotline number. Good luck. Cheers, Barbara

As mentioned previously, the balustrade and safety barrier regulations exist for good reason, ultimately to prevent accidental loss of life. No equal counter argument, period. Are they overly restrictive? Not necessarily. Are they tighter than other countries? Definitely. Can we vary them? Sometimes, if you can prove compliance to the deemed to satisfy provisions. Can we achieve the same aesthetically clean "no barrier" designs in Australia as simply and to the same degree as in other countries? No. But these more restrictive conditions don't necessarily equate to more restrictive architecture. Arguably we have to work harder and be more creative within constraints to get what I'd describe as quality and clever architectural solutions, but you know what? Too bad. And this is what separates "the men from the boys" so to speak (no gender inequality meant at all) I thrive on the creative opportunity within the constraint and it challenges our professional to go deeper creatively using the breadth of of skills to achieve results in arguably more challenging conditions. Its an easy cop out just to whinge about safety barriers or whatever the particular restriction is based on predominantly aesthetic/visual/spatial goals. Design solutions will ultimately reflect/respond to the contextual conditions. Yes outside of Australia there is less regulation around matters of safety that can be exploited by design solutions to sometimes achieve visually and spatially breathtaking results, such as in the images shown on this post. Like in all situations it's about balance and priorities and when practicing design and architecture in this country issues around safety are managed more robustly by regulation, which in turn naturally requires design solutions to work within the limits, which in many cases, due to the particular project priority stack and/or capacity of the people involved, results in less "integrated" solutions. At the end of the day, quality architecture is important and there's not enough of it here IMO, but that aside, safety barriers won't and don't prevent great or interesting architecture, but they do reduce/minimise loss of life, particularly young life, and that there I think for any project regardless should be the absolute highest priority, above and beyond any potential aesthetic or spatial outcome.

Hi Tina, Granites are non-pourous and really easy to maintain. When they are installed you should wipe them over with a liquid sealer; something like Rainstop and this will just give it an added protection, but you should not be concerned about staining (not sure where you heard this because it really is not a problem with Granite). The sealing process can be done once a year and it really is as easy as wiping your tops over with Rainstop, which is a thin liquid consistency like Terps, leaving it to dry for around 15 minutes and then wiping this over again with a dry clean cloth; it's that simple. Hope this information helps, regards Malcolm.

@Mc10 - We are also recirculating - and we are venting this through a gap in the kickboard where we will eventually also install a mesh / metal grill to keep bugs out etc. When the extractors in full flight it does throw out quite a breeze so make sure wherever you decide to vent isn’t somewhere that will annoy people who are sat - luckily where we vented is into where people just walk though. We hardly lost any storage if you look at the pic I posted what looks like the first drawer at the top is what we boxed in to price clearance and access - I think it was about 15 cms - not that significant as lots of storage space elsewhere.