59 Posts
Tom Pultz started a discussion
Are the Hudson Valley pendants 10" 2622 or the larger 13" 2623? - I'm asking because these look larger than 10" diameter.
    3 Comments
Tom Pultz started a discussion
Contractor Complaint Civil Suit (WA State) - Hi, I'd like to hear from anyone on GW, especially someone in the Seattle area, that has filed a civil suit against their contractor. Our lo... Read More
    25 Comments
Tom Pultz started a discussion
New Laundry Tub - Venting Needed? - I'm installing a large Kohler drop-in cast iron laundry tub in the main floor laundry toom and would like to know if this needs to be vented... Read More
    1 Comment
Tom Pultz started a discussion
Can You Have Two Fixture Arms for Kitchen Sink + Disposal? - The merge between garbage disposal and main sink drain with our current setup is problematic and tends to get clogged at times. When I insta... Read More
    10 Comments
Tom Pultz started a discussion
Panel Layout of Breakers - Does It Matter? - I've seen a couple of recommendations on panel layout and I was wondering if there' a conscensus on design or does everyone just do it "... Read More
    7 Comments
Tom Pultz started a discussion
Rough-in Inspection Checklist - Any Available? - I should be ready for my wiring rough-in inspection in about a month and would like to know if anyone has a checklist of items that should b... Read More
    9 Comments
Tom Pultz started a discussion
Can You Run NM-B Between J-Box and Wall Stud? (pic) - I have a few j-boxes where I've run NM-B cable between the j-box and the wall stud as shown in the picture. The cables are not pinched and t... Read More
    2 Comments
Tom Pultz started a discussion
Can I Put Dining Room & Living Room Receptacles on Same Circuit? - I was under the impression that the receptacles in the dining room were considered to be part of the small appliance circuits required for t... Read More
    5 Comments
Tom Pultz started a discussion
Lennox G71 Pressure Switch Error Code 228 - Debris in Sense Port - I would be curious if other G71 owners have ever gotten error code 228 and if so, whether they got the problem permanently resolved. When th... Read More
    2 Comments
Tom Pultz started a discussion
OK to Connect Flexible Metal Cable to Plastic J-Box? - I installed a metal junction box with receptacle in the firebox of our masonry fireplace. The new gas insert fan will use this receptacle. I... Read More
    22 Comments
Show More Events...