Hi Don, your question has popped up in the Australian Houzz site. American cabinetry has a greater widespread use of wood and painted wood than Australia. I'm envious. I'm not sure you'll get very much useful info here.

Hi, thanks all and apologies, all my mail went into the junk folder so I didn't see the comments. Yes I used the Annie Sloan chalk paint in graphite with black wax. As it was my first attempt I was very nervous. First I'd tried staining it with minwax polyshades - epic disaster! So I had to sand that down a bit as it was quite glossy and the Annie Sloan didn't stick. Anyway the lady in the shop Said to put clear wax on before the black wax which I did on the top but later I forgot and did black first by mistake and actually preferred that - so you can really muck around with it. I'm so pleased you all like it, my mother was very unimpressed and said she preferred it as it was but oh well, we like it. The paint is a cinch but the waxing takes quite a bit of elbow grease and not a small amount of lint-free rags (especially with black wax) and is quite expensive. Bill attached. Brush I will use again but used all the paint and almost all the wax. Still - Much cheaper than something new. I'm a bit nervous about tackling the large coffee table but I figure I can always sand it down again. The other option is a dark brown/black rub on stain called Java by General Finishes which I can get from the US by Amazon. It says it's the closest to the ikea brown/black Colour what ch could be good. I have another side table so I might try it on that one for a different room and then decide which looks best... Decisions decisions! May end up doing my awful but comfy walnut bed suite in the French Linen chalk pain half strength. I just hate it so much - it's so heavy and dated. Then I can add some nice pictures and make the room 'something'. Thanks for all the compliments - made my day!!

Hi dreamer, thanks for the suggestion. Im wondering though, how do I treat the junction between the vanity and the fixed panel of the shower screen? The diagram I uploaded above leaves out the shower head, so there will in fact be a shower-over-bath in the above scenario, with a fixed panel adjacent the bath. If I have the vanity hard up against the bath, I'll need to tile the side of the vanity, no?

Don't go with white. While it is easy to replace door fronts and drawer fronts you won't be able to replace the tall vertical panels adjacent to the fridge recess and the microwave recess without pulling out half of your cabinetwork. If you went with a white you wouldn't be able to match the same white as these vertical panels, and the new white would look off next to the old white or vice versa! I'm afraid there is no easy solution that will make the new doors blend in with the old vertical panels, so I would go with a bold contrast colour block that looks good with the white vertical panels, as well as the black granite. Perhaps consider a Piet Mondrian inspired kitchen facelift, by introducing some black edging to the vertical cabinets and a careful composition of blocks of primary colours? Best of luck, Dr Retro of Dr Retro House Calls/Dr Retro Virtual Visits