@urj123, Cricky!!! I knew you were going to ask that, after I looked at the sample I had that was full strength ha-ha.....AND I re-read you post and you wrote quite clearly 1/4 strength!!! I will return to the store, AGAIN, ha-ha and ask for 1/4 strength. All jokes aside, I think 1/4 will probably be real nice, as I didn't dislike the full strength but too creamy for the ceiling. My daughter actually painted all her ceilings the same colour as her walls with Hog Bristle but all the experts seem to say that a ceiling should be white or at least traditionally its always been white and I like the look of that too. I won't be back in town until next week but I'll keep in touch when I have the sample in my hand. Hubby and I are hay contractors and are at our most busy time being in tractors for many long hours but we are nearing the end and then I can take a breath and turn my focus back onto the home. Actually have 80mtrs of edging or capping tiles around the veranda to do and then the same amount of concreting to do on the 1.8m wide veranda and then we can get the colourbond roof on the house and during the cooler months, we can start to lay the limestone bricks, so there's plenty to do on the home!!! I have photo's attached in an earlier post. Best get to bed, more hay baling to do tomorrow. Cheers, Barbara

I once picked what I thought was a soft orange red for our bed room. It turned out to be Home Depot orange. As my husband refuses to paint a room more often than every 5 years, we lived with that orange. At least I was mostly there with the lights out, and it did make our north facing bedroom more cheerful. But for some reason we found ourselves at Home Depot much more often then!

We used an outdoor version of the concrete look tiles we used in our bathrooms. The tile have a rougher and slightly grooved surface which make them non slip. We used the same tiles as water line and pool coping. Once installed, we had a separate guy come in and hone the edges. Only cost a few hundred dollars.

We have a concrete pool and looking to do drop edge pool coping. Can the drop face act as the waterline tile and drop down to the bottom of the skimmer box?