Hi Eva. I am doing a reno and also looking at the same thing! I have found the Cavalier Bremworth at Carpet Court and really like it. It has a texture which picks up the colors around it and it's softer against the wood and tiles than other carpets I've seen. The attached pic is the colour Legato which is a mid range colour, but there are darker browns or greys and a lighter one too I think. The pic doesn't do it justice, but it really is lovely and worth a look. Good luck!

not good for the morning after!! although I could live with a feature wall or floor like the first one but not both, and, is that a wooden bucket on a hinged bracket in the shower??? thanks for sharing

You're welcome Jen. I think it was $70 shipping Australia wide. All feature herringbone tiles I'd looked at were so expensive and I found theirs for 65/ metre. I ordered extra and I'll use them for the Landry too.

You will need a bath with three or four tile flanges to match the one in the first photo. It has to do with complying with the building regulations for waterproofing and protecting the timber framing that is under the tiles. If the edge of the bath where it meets the tiles is not properly protected from water seeping through then concealed wet rot could start, and eventually everything will need to be ripped out, and built again. Sometimes even the timber floor joists under the bath rot out and need to be replaced. So I would do your research and co-ordinate carefully with your builder to ensure that the details are correctly built. Some builders will not go to the trouble of getting it right as they don't care if your bath falls through a rotten floor in ten years time. Quite often your choices in the bathroom should also take into account the long term functionality of the bathroom, rather than just the aesthetics. Best of luck with your research, Dr Retro of Dr Retro House Calls/Dr Retro Virtual Visits.