Lisa, Try sending the picture to some of the of the lighting stores. Ask if they don't have it where you can find it. Just ring the stores and ask for their email. Most will be quite helpful, especially if you do it at a quiet time like weekdays. Good luck ! PS I believe a re-shipper is a company that will buy it for you in the states and the send it to you, effectively a middle man.

This explanation may help, Source: https://www.renovatorstore.com.au/blog/lighting-and-power-in-your-bathroom-the-simple-rules-to-be-safe/ REQUIREMENTS Zone 0: Inside the bath or shower. Any Lighting used here must have a minimum rating of IP67 (protected against immersion in water) Zone 1: Above the bath or shower to a height of 2.25m. A minimum rating of IP44 is required Zone 2: The area stretching to 0.6m outside the bath or shower and above the bath or shower if over 2.25m. An IP rating of at least IP44 is required Outside Zone: Anywhere outside zones 0, 1 & 2. Where water jets are not to be used for cleaning purposes, the general rules of BS7671 apply In addition to the above, if there is a likelihood of water jets being used for cleaning purpose in zones 1 and 2 a fitting rated a minimum IP65 must be used. Now that this has been explained, always make sure to purchase bathroom lighting according to these standards to make sure that your bathroom is always safe. You should also have this principle applied when you purchase other electrical devices such as heated towel rails, or a guide to where you'd put sockets in your bath for razors and other devices. This may also fix the common misconception that LED lights are not rated for bathrooms. Typical LED lights have an IP rating of IP66 which is more than the needed IP rating standard that bathrooms should have. - Not to mention you'd be saving a whole lot from energy bills in the long run.

They look great in that photo, Northstar! Works beautifully. Will be fine over your bench. Didn't realise how large your p really space will be. Wow! No, if you replace pendants that have staggered drops, the fittings are completely removed and new pendant fittings are installed in their place. The electrician just shortens the drops without cutting them & the extra lenth is hidden away in ceiling.

try www.soniclighting.com.au They're more commercial and specialised lighting consultant/supplier (as opposed to sales/shopfront) but they supply quality products and particularly good with the more contemporary looking gear.... if they don't have it visible online more often than not they can source something