It seams like a lot of these threads are so old! People keep randomly finding a post that is a year or two old, and comment before looking at when it was posted. I wish houzz had a way of deleting old threads that where inactive!...

Have you tried to contact the company?

https://www.galvinhw.com.au/grace2/product.php?pid=4469 I found Galvins in Perth and Adelaide had the best range of pull, very well designed and so easy to use. No jammed fingers. I had 52 something similar to this. I could open with little finger when hand were dirty. Mine were rounder so looked like a full stop on the edge of the cabinet rather than overwhelming the line of the cabinets.

Hi Narella, most manufacturers of induction cooktops such as say Miele and Smeg make their 600mm wide units around 500mm to 505mm deep (front to back) where these fit comfortably into a 600mm deep cabinet, while still allowing for all the clearances, overhangs and venting required. You may like to check with your cabinet maker but as far as I am aware NEFF make their induction cooktops much deeper; making these 546mm deep instead of 500mm. This means that your cabinets also need to be deeper than the "normal" once all the required clearances are taken into account. I am not sure what you mean when you say this will not work with the rest of your cabinets. If you are positioning your NEFF cooktop above your underbench oven as it is shown in your original photo; then it appears that your cabinet maker has again done the right thing and has actually made all your adjacent cabinets the same depth; whereby preserving these clean modernist lines of your kitchen. Regards, Malcolm.