Well after a very (very very very) long time my Living Room is all but complete. There is some work to do behind the new steps and some trim to be put on the bookshelves. A light is to be put between the couches (that the electrical cable hanging down) and the wall lights are going to be removed. So just a quick rundown on what has been achieved; Two sky windows - Velux - roofing guy Sheeted under the beams - plasterer New carpet – Bunnings – carpet layer Closed off the old bar and put in a door – builder and plasterer Installed ceiling fans – Hunter, remote control, reversible – electrician Installed downlights - electrician Painted the endwalls – Solver Paint but Dulux Chine White colour - me Painted the ceiling – 2 x coats Solver Ceiling White over 2 x coats plaster board sealer - me New blinds (venetians) and curtains - from Spotlight - me Installed a gas bayonet heater (until I can afford a gas ‘wood’ fire for the fireplace – cripes they are expensive) – secondhand from Garage Sale - me Installed bookshelves – 2 x 202mm high + 2 x 106mm high Billy Bookshelf and 2 x Brimnes Cabinet - me Built and installed new steps and bench top on bookshelf – laminated Beech bench top, cut to size and routed, stained and oiled - me Sofas – Ikea Ektorp - me So some things I would have done differently. The downlights would be warm white not welding mask white. In fact I would re-think the whole light thing and possibly use lights with reflectors that were dark so that light was only reflected down. They would ‘lower’ the ceiling and make the room cosier I think. I kinda like the ceiling fans but had seen some which were awesome but really expensive. Then I saw ones very similar to the awesome ones but much cheaper but by then it was too late. I should have put bi-fold doors where the old bar was instead of a swinging door. I suspect that it will be unlikely now that I can use the room for its intended purpose. In fact with hindsight I coulda shoulda done the job myself rather than getting a builder in. It’s not as good as it should be and that has disappointed me. The bookshelves have come a up a treat – need to finish them off though with some trim. All from ‘Ikea’ except for the timber bench top. The bench top was a light bulb moment and breaks up the all-white appearance of the shelves. Also the white of the shelves and the white of the cabinet were slightly different and the bench has helped disguise that. The bench top and the steps were laminated beech panels from ‘Bunnings’ that I had cut to size. I stained them, put a router over the edge to round it off and then coated with Tung Oil. The bookshelves look bigger in real life than they do in the photos too. So now to sit and enjoy my handy work.

I think if you replace front door and glass panels as well as the old fashioned lights with something more contemporary it will make a huge improvement. I'd also remove the ironwork and as you cannot re-glaze place some pots and plants on the sides of the large windows to draw the eye away from all the green cross pieces on the windows. Eventually paint the gutters fascia in a light grey/green.

There is no problem at all with waterproofing a landscaped roof so long as you don't 'cut corners'. The problem arises if there are not adequate standards set for the supply of the product and the installation of the product. With the use of superior water proof membranes and installation by specialists there is no issue at all. This sort of roof is used all around the world.

A whirlybird might help but I remember the consumer magazine had an article about them years ago and they were more useful in some circumstances than others, it was not a matter on stick one on your roof and it fixes a variety of different issues.. As far as reducing heat goes, our neighbours lasted one summer with the whirlybird and then installed a cooling system. So I think a better understanding of the cause of the problem might lead to better solutions. What else is in your roof? Do you have insulation and/or sisalation? Do the bathroom exhaust fans ventilate into the roof space or are they ducted to the outside? Same question for kitchen rangehood?