Hi Joanna We love both! A common misconception we've found with freestanding baths and spas is that they're simply be too heavy to move around for cleaning purposes. To make cleaning manageable, our 100% Australian made baths and spas are manufactured using Gelcoat composite construction which is extremely strong yet not overly heavy (5mm thickness to ensure structural rigidity and increased thermal properties). So one of our baths is typically around the 40-50kg mark which allows most people to easily slide the bath out from the wall for easy cleaning access. Freestanding stone baths are a different story altogether! Regards, Brad AQVA Luxury Baths & Spas

This explanation may help, Source: https://www.renovatorstore.com.au/blog/lighting-and-power-in-your-bathroom-the-simple-rules-to-be-safe/ REQUIREMENTS Zone 0: Inside the bath or shower. Any Lighting used here must have a minimum rating of IP67 (protected against immersion in water) Zone 1: Above the bath or shower to a height of 2.25m. A minimum rating of IP44 is required Zone 2: The area stretching to 0.6m outside the bath or shower and above the bath or shower if over 2.25m. An IP rating of at least IP44 is required Outside Zone: Anywhere outside zones 0, 1 & 2. Where water jets are not to be used for cleaning purposes, the general rules of BS7671 apply In addition to the above, if there is a likelihood of water jets being used for cleaning purpose in zones 1 and 2 a fitting rated a minimum IP65 must be used. Now that this has been explained, always make sure to purchase bathroom lighting according to these standards to make sure that your bathroom is always safe. You should also have this principle applied when you purchase other electrical devices such as heated towel rails, or a guide to where you'd put sockets in your bath for razors and other devices. This may also fix the common misconception that LED lights are not rated for bathrooms. Typical LED lights have an IP rating of IP66 which is more than the needed IP rating standard that bathrooms should have. - Not to mention you'd be saving a whole lot from energy bills in the long run.

Moving the niche is not an option at this point. But I do have a question about the niche. My tile installer wants me to consider using the gray tile (same as the floor) on the inside edges of the niche. This is because the wall tile is glass and imperfections in the glass (from cutting it) will show if the glass tile is on the inside edge. How do you guys think that would look? I tried to find photos of a niche where the wall and back of the niche were one color, with the sides being a second color and I couldn't find any examples. Has anyone seen that?

Hi Denise, They are stunning, closest I could find are these from max sparrow , they have a metal wrap around but I am sure they could be made without, but quite expensive but gorgeous.