These 4 photos showing some window tinting done to add to my priviouse article . A house in Penguin Tasmania overlooking the sea with privacy an sun problems using a dark neutral based film showing one sheet of glass done an one with out with the second picture showing the glare reduction on the floor as a comparison . This demonstrates little reduction in quality of views overlooking the sea but offers many benifits to the customers with out having to close blinds / curtains etc. The other two showing the full reflective film on a commercial shop front with views from both inside and outside as a comparison . ( please note; taking photos facing windows will often result in misleading picture quality due to any glare present , thus resulting in misleading darker looking window views than what normally results from using most tinted films .) The actual light reduction difference between these two films is approx 9% with the reflective being the darker of the two and comparable to a popular dark grey low reflective shade that's also widely popular . Any one requiring some unbiased comments regarding this subject are quite welcome to call me . Although I live in Tasmania , I do offer my services not only Australia wide but also overseas if the need arises . As to the life expectancy of these products . As these are manufactured world wide , the quality ( or lack of) plus the degree of experince and willingness of the installer to make sure they want to try an do a good job ; can make a Hugh difference to the last -ability . Therefore, take care on choosing the film and installer ; and don't buy on price alone. Gary. Protek window tinting (Tasmania )

The answer to the colour is here on another dilemma, Resene Stack [Colour used on this house[(https://www.houzz.com.au/discussions/could-you-please-tell-me-the-colours-used-on-this-house-please-dsvw-vd~1274539?n=4)

Hi Fiona. Those boards were replaced after initial build (after installing new wider slider), so that’s why they were lighter. It was weathered and needing a clean and recoil there. I took cutek’s (expensive)advice and started with quik clean (loosens dirt which was evidently incorporated into my layers of oil), then followed with pro clean (timber brightener). I scrubbed my butt off and was still not happy with the result. It just didn’t evenly clean it up, and I used fairly concentrated doses, and got down on my knees to scrub, not just a brush on a long stick. I oiled with cutek extreme (instead of cd50). Some more pics, after scrubbing then after oiling (still dark). I did redo my handrail in johnstones deck oil, and it appears to be lasting well, no peeling... but I’m still a bit cautious about risking my deck with this finish (water based over oil). I think I’d prefer dirty weather deck than a peeling finish. Next house I’m only having timber deck if it’s entirely undercover!! Do you have a similar dilemma?

I've coated many decks and the best advise I've been given is "leave it natural". Most timbers go grey after a few months and don't look too bad. If you want a bi-annual maintenance job the other bit of good advise I've had directly from the manufacturer is put down four coats minimum. The third and fourth coats won't use so much oil because they don't soak in. A very light sand between coats keeping in the direction of the grain is a good idea to retain a finish without wood grain or dust spoiling the final appearance. Two coats, no matter which brand or type of oil will last about a year in our sun.