Id do a pergola with clean lines with retractable blinds/shade in the roof part. There are some DIY blinds on Pintrest. For your windows I think external blinds that stop the heat hitting the glass are your best option.

Judging by the plan, the photos and your comments it appears that too much heat is coming in from high light glazing (clerestory windows) into the lounge and dining areas. Both rooms will be cold in winter because the direct heat from these windows is not enough and not absorbed in an thermal mass and they do not have ground level windows or glazed doors facing north. The elevated floor means that it is cold under the house so heating in winter goes down as well as up. The roof would lack adequate insulation due to the period in which the house was built. The roof tiles probably have another 15 years maybe a bit more so it is costly to insulate from the top (i.e. taking roof tiles off adding insulation then putting roof tiles back in again. The colour of them is contributing a lot to the heat. So what to do. - add external shading device to the highlight glazing, maybe timber battens 40 x 40 at 20mm spacings. This will block direct sunlight within the shading season. That helps to reduce heat intact and see how you go. If that does not work then - add a rigid foam core board to the underside of the timber ceiling, e.g. Foilboard which is 20mm thick r 2, then install a 12mm plywood ceiling lining under this. That way you retain the timber rafter ceilings but also one that has a light coloured (hoop pine ply) timber in between. (Note this is costly) - big gains in heat loss is achieved with underfloor insulation. Try r3 bulk squeezed tightly between the floor joists. Then you can plan for the future with the following - change glass in windows and glazed doors to a low e glass - install insulation into the cavity of the external walls using a company called envirowall. - replace roof tiles with a light coloured metal roof, replace the existing roof battens with a 100 x 40 batten so that you can install a 100mm thick anticon insulation. All of the above costs money and if you don't do it then it costs money to burn energy to keep the living rooms between 21 to 27 degrees year round (what we consider comfortable) so if it tough to decide what to do or not. As an alternative For about 40k you could spend 30 of it on solar cells, and an awesome battery (Tesla powerwall 2) and buy some wall mounted ac units. But that would be kicking the can down the road. But sometimes you have no choice. Good luck

I love your view! There's options here, and they'll be led by where your blinds are installed in my opinion. It looks like you might need to install the blinds to the face of the architraves, in which case, I'd be selecting pale blinds to sit outside the window as they'll, hopefully be up out of the way most of the time. If they fit inside the recess, then I'd select dark.

The short answer is, Google isn't telling you the whole story. Tinting your windows won't reduce 90% of the heat unless it blocks 90% of the light coming through. If you wanted to reduce heat coming in, go for something like double-glazing, with low-e coating and Argon filled cavity. But I think you already have the windows installed so that would be pretty expensive. Another option would be to look at some horizontal shading to cut out the direct sun in summer. The photo attached is your actual house? Something like an awning is probably out of the question, but maybe you could make use of some horizontal slats. This article has some ideas for external shading https://renew.org.au/renew-magazine/buyers-guides/external-shading-buyers-guide/ Other than the above, making use of natural ventilation if possible will make a difference. Ceiling fans will probably make a noticeable difference. And of course the window tint will make some difference, but I doubt you'll find it's the complete solution on its own.