Thanks dreamer, might look into a sliding window for the splashback. And have put the benchtop as 650mm for now, may increase further. Thanks siriuskey. I am leaning towards your design and using the corner as appliance/pantry. The bifold from bench height up would certainly work really well functionally but I’m not sure I’d like the look. I’ve sketched up having the area 800 deep to house the fridge and to have a step in pantry/appliance cupboard (500 deep bench, 300 step in cavity). 2 variations of the cupboard, first with sliding doors opening from centre (approx 1m opening so might feel a bit pokey), or second with perhaps stacker doors to right or bifold (this would block off bench space between pantry and sink when open though). This cupboard would be pretty big (2280mm) so don’t think we’d need the appliance cupboard next to dining area. And could have oven under cooktop. Dining and kitchen could be separated by small wall.

Hi Jasmine, I just want to ask you a couple of things re details in the plan an will post showing my concerns. Along the back wall, change the wall/panel on both sides of the fridge to 20, the wall would be approx 90?, this will give you an extra 70 space to play with, this would also balance the built in fridge between both sections of cabinets. As it is your designer has used the wall on the left of the fridge to line up with the wall of the proposed pantry, but I feel this isn't needed the panels will do a better job..without taking up more space and not looking so bulky. So now you will have extra to play with and could consider 900 x 2 drawers plus 900 cooker. What is the corner cabinet, it looks like having one door opening along the window wall? I have an 800 sink cabinet which has 2 x 400 doors which are perfect as they don't open out so wide into the room. would it be better to move the DW to the other side of the sink so as not to block access. 900 space at the end of the island is too tight and should be at least 1m The wall cabinets above the cooktop, are they all single cabinets?, it is more cost effective to use double, I ask this because the plan shows that two single or two double cabinets will be involved in installing the intergrated range hood.

Your renovations are well underway, so after seeing the small floor plan and that the vanity is on an internal wall and you apparently still want the Shaving Cabinet. Having cavity brick walls I would get your brickie to remove a section of the brick wall so that the shaving cabinet can be recessed back into the cavity, this will overcome any concerns you have about bumping your head, this opening can then be patched along with other walls. I would take all of your photos and measurements to someone like Reece to pick a hand basin to fit,, I would also keep in mind that if say the width of the vanity is around 900 the shaving cabinet would match that width and you would end up with say 2 x 450 mirrored doors, which puts the mirror join in the middle and in your face when using the vanity. cheers

Also take into account the width of your benchtop material. You’ll save money and avoid a join if you can stick with a standard size. So a manufactured stone will be about 900ish so with a standard benchtop about 610mm-ish you have up to 290mm to work with.