Hi Mike and Emma Hope you are slowly but surely getting there... may I make some comments/suggestions that you may or not take on board, but hopefully it may at least give you some ideas/options... Going through a new build ourselves at the moment, and for what it's worth, here's what I personally think: A. Work with what you've got: - additional plumbing work, gas work etc may not be necessary and (particularly gas) can be costly when you're trying to work around existing walls, floors, etc, and as much as possible utilise the existing connections... after whatever you can save here and there, you can spend on nicer cabinetery, gadgets, finishes, etc :) B. Avoid unnecessry structural work: - removing the kitchen/living wall is a must (more space, light, etc) but removing the laundry wall is an unncessary added cost (may even require costly additional strutural support) - putting up a plastered wall on the other hand is inexpensive, allows you to redefine different zones and relocate doors/openings where required (*note: avoid hinged doors in small spaces as you have to allow for wasted space to open door - suggest cavity sliding doors, easy to incorporate in a new wall) C. Don't sacrifice functionality and natural light for design - love full height floor to ceiling cabinets, very much on trend... but they also tend to bring the walls in, which you want to avoid in an already small space... they will also block out more natural ligtht from the only window to the living and breakfast bench (meals area)... not to mention seated guests would be staring at a cabinet tower and fridge - on the other hand a walk in pantry (not that much of a walk in a small space) is also very much on trend, provides more storage and... as entertaining guests in open plan livings tends to happen more in the kitchen... it provides a good hiding place for unsightly items, including frigges... (an underbench bar fridge in the kitchen can easily keep those beers cold... though do consider that means sacrificing some cabinet space) - constantly wiping off the floors from dripping wet dishes across the kictchen from the sink to the dishwaser on the other side bench would personally drive me mad after a while... the dishwasher can easily be connected to the existing sink water and waste points through the cabinerty... any half decent plumber should be able to do that... ON THAT NOTE... or should I say those notes... I know I got a bit carried away :) ... if it were me, here's an idea of what I would try to achieve ...

I'm about to put a cooktop on the 2.3 x 900 peninsular (island with only one free end ( in my new galley kitchen. I am using an induction top so it can be fitted flush with the benchtop surface, allowing me to use the whole area as benchtop when not in use. I intend to have bar stolls on the living room side for entertaining. My joiner has suggested making a beautiful, thin timbercover to go over the glass induction surface for added protection. I just need to decide on down draft induction hob or a ceiling casette. My main aim is to remove the smelly cooking smells from my unit. The smell from one evening of cooking indian chicken curry currently lasts at least a week! Any advice?

Hi all, I'm new to this and would like to any feedback from others who have installed refrigerative air conditioning with ducts under a raised timber floor, and what issues they may have experience by using a common heating and cooling ducts. We are also building a new home that will have raised timber flooring so we can install ducted heating but, in our case, there is no roof space to install ducts in the ceiling in any case because our house will have 2 skillion roofs, one at 15° and the other at 7.5° pitch, both meeting in the center of the house, and running the entire length of the house. The other challenge we have is that half the house along one side will have raked ceilings in the living, dining and kitchen areas and will extend along the entry hall way, whilst the other half of the house where the bedroom bathroom laundry etc., will have flat 2.75m high ceiling and the available roof space will be minimal. The option of ducting the cooling beneath the house is attractive because we also don't need bulkheads.

Progress picture for those interested :) For paint, I'm going with SW Khaki Shade (first floor) and a bit lighter SW Sand Beach (second floor) with white trim/white grout (stone not yet grouted)