After I had finished my Archi Masters I was working for an architecture firm who also did a small amount of work for a volume builder. They were actually a pretty good quality builder and at least got the orientation of their 'pre-designed' plans correct. We had the ability to make minor changes to every job and it pained me to see so many simple to implement passive options not being incorporated. Had most of their clients known that they would be saving MONEY over the longterm by making a few minor changes to suit their site, they all would have done it. The problem is unless someone can sell this idea to them as a financial/lifestyle choice, many just think it is about saving the world. It is a no-brainer if you have in interest in it, but for those who don't know, there is no-one there selling it to them, especially on the lower end of the market.

we're building in Childers Qld (Zone 2) on top of a hill 120m above sea level with no chance of being built-in as we are on a 69 acre block. Quite windy all the time predominately from the SE. All outside doors will be security. Roof has vents in the gables on all four sides so I can leave open to purge heat during summer and close off in winter. Bed 2&3 doors used to be adjacent bathroom door for cross breezes but a layout change in the bathroom meant having its door on the east now. Not ideal but necessary. Dark colour unfortunately is dictated by our very red soil that will stain any light colour so had to go dark, would of preferred light. So I should make my eaves 1200mm all around?

Hi maryprior892 Thanks for posting the extra information it all helps in gaining some understanding, I think it is possible to improve this existing house in a cost effective manner. Just a minor item that I picked up in regards of equipment - I think you mentioned that the existing STORAGE is actually a covered internal courtyard - I also notice that you have a hot water unit in this space - you should check that the hot-water service (if it is a gas unit) that it has sufficient ventilation and is not an external units that has been closed in - any plumber will give you this information - enclosing gas units that are designed for external use is not a good idea. I think that if you are going to make changes it not only should suit you, but also have a good resale opportunity - considering your upstairs areas it might be better to add a decent En-suite and walk in robes and getting two or three bedrooms downstairs - in this way you would have parents areas separated from children - this might have better resale and use that a tiny ES. The third bedroom downstairs could be gained by enclosing the RUMPUS room and providing access to bathroom areas by a corridor to existing bathrooms. This would also aid in getting containment areas for heating - at the moment the plan shows one open space including the upstairs - lots of heating in winter in Tasmania for all that area - some compartmentalization would probably help in combating yearly heating costs. The existing living area are certainly ample, so the loss of the rumpus to a bedroom does not detract greatly to the overall house, and in the meantime you could use the new downstairs bedroom/rumpus room as you have already mentioned as a library. I think this is achievable, but before doing a physical change, I would have a fully developed plan which includes all existing and proposed furniture to scale, with a few 3D views to enhance the concept. (It easier to change drawings than walls - a lot less dust and much cheaper) I would then obtain the opinion of a Real-estate agent (the Real-estate agent you bought it from is not a bad place to start) and maybe two others. This might help in making long term decisions in regards to investment for the future. Staging your proposed renovations is also another approach that you might investigate. Above all I would retain and obtain as many ocean views that you can possibly get, I assume that the ocean views are at the front of the house (" revealed an open fireplace in the front lounge which also has ocean views so that is fabulous.") If possible you might consider developing an external eating/sitting/entertaining area with ocean views - I certainly would be a buyer, and I would assume that it might be supported by the real-estate agent. I hope this is of some help, I would be happy to comment further on this design as more information becomes available. Michael Manias Manias Associates Building Associates mm407p@gmail.com

About your question about sourcing some of your own internal fittings. It is best you discuss this with the builder early on. Usually, the builder's contract will specify an allowance for particular fixtures. However, some may specify actual brand and model of fittings ie taps, toilets, sinks, etc in their quote, and they may or may not allow you to vary this. IF you are happy with those specified fixtures and you think the allowance amount is reasonable, then you can go with it. Otherwise, any changes or variances need to be discussed with builder, and it is very important this be discussed upfront and before any contract is signed. Some building contracts may also disallow some variances. In any event, carefully read the contract so you completely understand what you are agreeing to, and discuss any and all parts where you are not in agreement so these issues can be ironed out. Also, and this is my own experience and opinion, but I advise specifying in the contract the completion date AND if the build is not completed on time then what happens (consider that you may be paying interest on your mortgage, be financing a bridging mortgage, etc. and/or you may also have already sold your home and then have to pay rent until the build is finished). If you are in agreement with builder to source some of the internal fittings yourself, there are any number of suppliers and sources to investigate, and this might be a good way to keep your budget in check. There will be Houzzers who are experienced at this and can provide you with ideas. Just keep in mind that you will have to have all fittings READY and ON SITE when the tradesmen require them, otherwise you will be holding up the build and that is going to cost YOU money.