Rellish, did you have trouble getting matching grout and silicone? We're about to use the exact same tile in our bathroom. Also, did the tiler have any trouble due to the embossed pattern? Our builder thinks we need to install the tiles on top of the vanity as the tiles are not flat and it will be difficult to get a good, clean seal if the wall is tiled first.

https://www.galvinhw.com.au/grace2/product.php?pid=4469 I found Galvins in Perth and Adelaide had the best range of pull, very well designed and so easy to use. No jammed fingers. I had 52 something similar to this. I could open with little finger when hand were dirty. Mine were rounder so looked like a full stop on the edge of the cabinet rather than overwhelming the line of the cabinets.

I was about to say all our handles are the same size, but they’re not. They’re all proportional to the drawer width. A combo of 165 on 440, 230 on 590 & 760, and 355 on 960. I remember I probably drove the cabinetmakers nuts cos I couldn’t make up my mind about what, to them, may have been a such minor issue! Handles! I feel for you/know what it’s like. :-)

In the interest of keeping your kitchen friendly to as many users as possible, may I suggest you avoid knobs of any description. Older people and those with disabilities/reduced function of the hand/arm/shoulder often struggle to grasp and pull on a knob. 'Push' closers and D (or U) shaped handles with a min of 50mm height from surface are much friendlier in this regard. We are building our retirement home and - although we are both well and dextrous at present - it is so easy (and much cheaper) to think ahead, we're discovering. Setting up the place to be comfortable for as many users as possible is also pretty satisfying. Personally I'd like brush satin steel long D handles with an elegant line. Black on black might be hard to see for some and in low light.