Thank you Chook, Chook 2, your advice worked! In the pictures you enter the house with the grey tall wall on your right hand side (the floo) and the cream wall with the bulk head (for the bocci lights) ahead. It is very limited space, in picture 1 you can slightly see the front door on the right hand side next to the opening. So my dilemma is what I do with the floo wall to not detract too much from the feature wall. Thank you Brandi, I like the idea of the mirror, however I am concerned it will give off a cold feel to the house and want a more warm, rustic feel. Also would you cover the entire front panel in glass or a framed mirror for part of the wall.

This explanation may help, Source: https://www.renovatorstore.com.au/blog/lighting-and-power-in-your-bathroom-the-simple-rules-to-be-safe/ REQUIREMENTS Zone 0: Inside the bath or shower. Any Lighting used here must have a minimum rating of IP67 (protected against immersion in water) Zone 1: Above the bath or shower to a height of 2.25m. A minimum rating of IP44 is required Zone 2: The area stretching to 0.6m outside the bath or shower and above the bath or shower if over 2.25m. An IP rating of at least IP44 is required Outside Zone: Anywhere outside zones 0, 1 & 2. Where water jets are not to be used for cleaning purposes, the general rules of BS7671 apply In addition to the above, if there is a likelihood of water jets being used for cleaning purpose in zones 1 and 2 a fitting rated a minimum IP65 must be used. Now that this has been explained, always make sure to purchase bathroom lighting according to these standards to make sure that your bathroom is always safe. You should also have this principle applied when you purchase other electrical devices such as heated towel rails, or a guide to where you'd put sockets in your bath for razors and other devices. This may also fix the common misconception that LED lights are not rated for bathrooms. Typical LED lights have an IP rating of IP66 which is more than the needed IP rating standard that bathrooms should have. - Not to mention you'd be saving a whole lot from energy bills in the long run.

Hi Crocker Castle, We bought our tiles from Tile Mega Mart in Smithfield, Sydney. We got ours on sale + further discounts as we bought both exterior and interior tiles from them. Cant remember the exact price of the timber look tile as it was an overall discount. We did get it for a reasonable price and much much less than the advertised price of $129.

I wouldn't go any lower than 600mm from the top of the bedside table. Ultimately the height would depend on the height of the bed and the size of the pendants you are using. Hope this helps, MKG