Hello again, thank you for the input. I've taken it all on board. Regarding the island, we will be sticking with Knights Grey but if we choose a very dark floorboard, we will then switch to Timeless Grey (which happened to be one of the swatches I'd picked up anyway!) to avoid that sinking effect. Thanks for the tip. I won't be able to get back out this week to check the Dulux Raku colour, did I mention that I'm getting around with a 1 month old and 2 year old? They are totally dictating my schedule! Ann I'm not sure exactly how they get half strength. I just have the understanding that paint looks darker on a wall than it does on the sample card so to always opt for a lighter shade to counter that effect. So to avoid the Snowy Mountains colour looking too dark, I will go for a half strength. Worst case, I figure, is that it will just be a touch lighter than what I'd expected. There wasn't consistency between the three separate Snowy Mountains cards that I ended up with so I guess it's to be expected anyway. Thanks for sharing your experience Antonia, it's good to know it works. Today I went out to Beaumont Tiles to try and find a tile like the one I attached to my original post. This was surprisingly difficult to match and I've borrowed a sample of the closest match from the store to mull it over. The colour seems to work quite well against all my samples but I'm worried about the wavy edge and how it will appear on the wall when grouted. On the one hand I'm worried it will look too busy or untidy, on the other hand I think it could be a winner because it could add some depth or interest to an otherwise boring subway tile splash back. I've attached the tile against my samples and also Tranquil Retreat (half strength) wall with Vivid White trim. Please tell me what you think :)

I suppose the question is "What are you going to do with the untiled wall?". Will it just be painted plasterboard? If you do decide to just go with the 200mm tiled splashback you will need to be very careful with your tile selection with the sizing and how the edge of tile looks. You should probably select a 200mm tile, as you don't want a cut, half tile in the space between the window sill and benchtop. Some glazed, ceramic tiles also have messy edges, so make sure that your tile selection looks as good from the edge, not just the front, as you will be looking down on the top edge of the tile. Or allow for a tiling edge strip to conceal the edge, but these always make the space look visually busier. With so much happening in your kitchen with the open shelves etc, I would suggest a plainish, neutral tile and tile up to the ceiling for a cleaner, more streamlined look, that doesn't need maintenance and repainting in ten years time. Open shelves often look better against tiles. By tiling to the ceiling there is no exposed tile edge to look messy, which gives you a wider choice of tiles. Best of luck, Dr Retro of Dr Retro House Calls

In every home, there are spaces where old favourites are the most appropriate window or door of choice – and even this modern home is no exception to the rule. Truly a home “with the lot”, this beautiful property's luxury design is completed with the use of... Sliding windows in the kitchen and bathroom; providing a natural balance between light and air. Double-hung windows frame the barbeque, while a fixed window creates a natural light-emitting kitchen backsplash. Louvre windows in the bedrooms and bathrooms, allowing fresh air to circulate. This beautiful custom home was built by McLachlan Homes.

Hi Mimi, Your stone (probably Marble or Reconstituted stone as these can be damaged by acids) has been factory finished by diamond polishing to get the gloss level it has. A sealer will only help protect that factory finish and unfortunately it will not bring it back. The bad news is it is not possible to repair and so removal and replacement is the only real fix. This may be covered if you have Accidental House Insurance, but other than this, I am afraid there is no easy fix, sorry. Hope this helps though, Malcolm.