Seriously you need to check out the Kerlite cladding. No need to sand, the variety is huge even wood look. All you need to do is put on a thicker screed. As I said you do need a tiler that has laid it before. Once it's down, it will never break. Google it, the range is amazing and really beautiful. I did ask the tiler about using it over slate and he said not a problem. Got mine from tile expo.

Well, I did a trial with a few tiles and then covered them with polyurethane. The trial didn't necessarily go entirely to plan but I was able to establish that PU will be too soft. Epoxy is likely to yellow even indoors, so that leaves me with the following solution: 1. make the tiles thicker (not a big deal) use tile selection and a thicker tile bed to enable a relatively flat surface to be made 3. seal it with a thin polyurethane to protect from mess Thanks for the contributions.

I will be the loan naysayer and go: Vinyl Plank timber pattern tiles. I did these in my kitchen and they helped make the room. Used Karndean, but any European brand should be fine (avoid American and assume they are using American or worse if they don't say the country of origin). http://www.karndean.com/en-au/floors/landing-pages/new-looselay-longboard?gclid=CjwKCAjwspHaBRBFEiwA0eM3kQ7eEFPH5FlK2IwV3o7ZsbbmJ19srG0OM_tWK5dhPMNyDdwxGPUr4BoCoYcQAvD_BwE Caveats: Ground must be FLAT. 100% flat, ruler FLAT. If not you will have to level. If flat, you can lay them yourself. Our floor had to be levelled and it was tough. still got a few high patches and gaps because of that. However I have done it on a concrete surface myself since and it's beautiful. Benefits: Nice and soft on the foot. (less ankle pain) single tile replacement. Looks fantastic. No PVC glue fume issues and fairly resilient. Do be wary though of metal chair legs scraping the floor. Waterproof! when installed right with no gaps! (why I would choose them in a kitchen over timber or Eeek carpet!.... Yes previous owner installed shagpile carpet in the kitchen).

I took into consideration your new Fridge pantry alcove when I designed your kitchen to get you the max island and still being well placed within the kitchen. If the island isn't attached to the fridge wall you would need to leave a 1m space between them which would reduce the 3m Island as I have shown, the dotted wall shows the length of your kitchen, and how the island fits into that space, you could extend the island further into the dining if you wanted, I can redraw that for you. As I said with both of your plans drawn differently Both OKL and myself had a differnt result