Will look much better white BUT! Having done this to big old sliding doors and window frames in an apartment with more ‘steps’ in the frames there are a couple of things to watch out for. Sealing - as mentioned in another post is essential, if the wood is stained then the colour will come thru to the paint. I did this just as the manufacturers were getting the water based enamels right and have done several recoats since. Agree that Zinsser are great paints, I have used their wall and ceiling paints everywhere, cost more, are a bit more ‘drippy’ but also have a sealer component and actually do a real white that doesn’t yellow. They also last really well on the wall. When you transform to white - especially if you are thinking high gloss EVERY defect in the wood surface will show up. This adds to the charm or is a problem, depends on your perspective. I dropped back to a satin finish on wood trims. There is only so much prep you can do, sometimes it is easier to fix the obvious dings and then do another round after the first coat of white, after the sealer. This is harder to explain - but you can end up with a dark line around each window pane - because the glass is sandwiched between two pieces of dark coloured wood and the ‘inside’ of the wood shows through the glass and you notice it from across the room. I painted slightly onto the glass, a few millimetres to achieve a fully white effect. You only notice it if you look closely. Fly screens - wooden fly screens have the same ‘edge effect’ metal flyscreens are a bit easier to paint. They all look significantly better in white than the dark wood - in my case the two sets of sliding doors have very wide frames. Depending on your skills and patience you may want to get a professional. I am about to replace the south facing repainted bathroom and study windows with double glazed UPVC tilt and turn with white frames - no more arctic bathroom, jammed winder, condensation or mould. These are now made (licensed) in Australia so only have to pay for shipping from Vic to ACT rather than from ‘overseas’.

Timber and brick house built in the 70’s. All exterior trims originally painted Mission Brown plus colorbond on garage doors. Updated in the 90’s repainted with lighter sand colour to match bricks. Another paint job required for 2018... what paint colour would suit modern ideas? Fascias have been replaced and undercoated. Any ideas or suggestions would be most appreciated. Thanks

Try dulux snowy mountains. Just hope you plan to bring some colour and textured elements into space. With the tiled light floor, the effect might a bit cold.

It is 'of a certain era' , and without spending big $$$ , that's always going to be the base , and why not ? I'd take the cue from the lower brickwork , and do the windowsills and gutters in a tone thats more charcoal than brown , but with a slight brown aftertaste . Likewise , I'd redo the upper level in weatherboard , whether its painted , coated , synthetic , but personally I wouldn't mix styles -- scyon or render done in that orange tone will look like an obvious add-on ( yes , I know , the well-worn boards do that too , but look at how the concrete railing has come up with a paint ) . Basically , keep it looking like up-dated period IMO . Basically , get rid of all the green , and the awnings , and work with the orange , the 'interesting' aspect of the brown , the roof , and the small bit of white .