How funny. I just renovated (on a budget) my small kitchen and added exactly the slate look in tiles you have, though they are in fact porcelain. And I placed them throughout the house for continuity. The tiler asked if I was after a retro hippy look but it doesn't look like that at all. My cupboards were the same colour as yours and I utilised the bones of the kitchen and had the doors and Benchtops changed only. I also have plenty of light in the kitchen but chose white doors and as I was on a budget I chose granite look Benchtops, they are very serviceable and it looks great. The blue backsplash was the colour lift and here you could choose any colour to your liking. Basically the kitchen ended up with white cupboards and appliances other than cooktop, with the stainless cooktop and coloured splash back being the focal point. The paint colour are: whisper white walls, integra splashback, white ceiling and for increased contrast I used the same white above the splashback on the rear wall. I would consider painting out the brick but leaving the texture.

Hi Amanda, the hexagon tiles on the floors will absolutely look great too and if that's the dream, then go for it. Personally, I would also try to run the hex tiles up and over the bath hob if your budget allows. A light grey grout (instead of white) and also sealing the grout properly will help to maintain. I like both vanities, they are very similar, and would probably go with the one that offers the most drawer space as there's not a lot of storage in the bathroom (speaking of which, add a niche in the shower area if you can). Also bear in mind the toilet roll holder and make sure it can be fixed to the side of the vanity despite the drawer (as you can't fix to the other side of the toilet which I presume will have a glass shower screen). Lastly, I know you've already mentioned white, but have you considered timber (or timber-look) panels for the drawer fronts? It's just a suggestion, but it will bring some warmth into the modern space and may also be another way to tie in with the federation style of the home. Found those couple of photos to give you an idea how you can introduce timber... https://www.houzz.com.au/photos/designer-bathroom-project-contemporary-bathroom-melbourne-phvw-vp~32381930 https://www.houzz.com.au/photos/neutral-bay-house-contemporary-bathroom-sydney-phvw-vp~19885477

Hi Doug, looks great! regarding the floor my only suggestion would be to avoid the grout line down the centre as you have it. it is the first thing that draws your eye, and if you are going to the detail and expense you are then looking down is not what is going to show it off. From that I mean make it complementary to other things not competing.... eg a simple 1/3rd 2/3rd off set to break up the line and allow your ceiling feature to draw the eye. cheers

Unexpectedly to me, due to it's location on the crest of the Great Dividing Range at an elevation of around 700m above sea level, Toowoomba has a climate more similar to Sydney than Brisbane. With average summer highs of only 28°C, & average winter highs of 17°C (lows of 7°C & cold wind, as has been mentioned). It's located in Climate Zone 2: Warm Temperature, the same climate zone as Sydney, not Brisbane. Though this climate zone is very varied, so care must be taken to cater for local conditions. As has been advised a few times, have a good read of the Your Home site. Read this section, Designing for Climate, for zone 5: warm temperate. http://www.yourhome.gov.au/passive-design/design-climate Along with having cooler temperatures than Brisbane, the fact that Toowoomba is inland means it has greater variation between daytime highs & nighttime lows (diurnal temperature range). This means that unlike Queensland coastal climates, some thermal mass in the home will be appropriate, so a lightweight structure isn't needed. Although a lightweight structure, on a ground-coupled slab (with polished concrete or tiles in North facing living areas) would be a good idea. As the temperature is so much cooler than tropical Queensland climates I'd advise against going too overboard with a pavilion style house. As I think it would be too cold in winter. Maybe something like two off-set rectangles, joined in the centre. Kinda like dreamer's inspirational picture, without the middle section, the two rectangular sections joined. Or just go for a more traditional rectangular house. In any case, like just about all Australian climates, you should try to build a house that is generally rectangular, the long sides facing north & south. This will give an opportunity for northern sunshine to enter home in winter, while the shorter eastern & western sides will limit the effect of hot summer western afternoon sunshine. Though I guess this house shape won't look great from the western road, as it will look very narrow from here. You could fatten it's street frontage a little bit, by having the garage to the south of the rectangular house. With such a large block you'll be able to build something that works for you. But as OKLouise said, don't just pick a plan for an average narrow block. The plan you picked is not really suitable for your block. I'd also recommend you do a lot of research yourself. As has been shown with the plan you've received, you can't rely on the builder to design a plan that will work best for you, that is appropriate for your location. So read up on the Your Home website. It's an invaluable resource when it comes to building a comfortable, energy efficient home.