because the water could seep through the joints between the new tiles and sit between the two layers and affect the seal and also raise the height of the floor and affect the slope to the waste outlets..but, why do you want to retile if you're not using the bathroom??...for immediate resale consider bathroom wall to wall bathroom carpet, new wall paint, new vanity, taps and light fittings which should also be cheaper than tiling over the top and, if it's not allowed by the body corporate, it will be a risk to future sales as it should not satisfy a proper building inspection

Nup, a good tiling job requires a good substrate. The best tiler in the world can't make a bad substrate look clean and good. No point on spending money on new tiles and a good tiler over an inferior base. Rip it all down, start again and get it right before tiling. Best of luck, Dr Retro Of Dr Retro House Calls

Hi there, tiles on the floor of a bedroom? It sounds a bit cold underfoot unless you are having underfloor heating installed, but then perhaps you are renovating in warmer climes than where I live! I would recommend going for a matte or satin finish in the bedroom as the gloss could look a little sterile.also If you have a connecting ensuite, you wouldnt want to run the risk of slipping on the floor if you have wet feet :o

You may be lucky & the tiles may come off easily if just laid (we just did this in our shower). Worst case when they pull them off they may damage the membrane, in which case they will need to repair it, so it is just the time of the repair & drying, before they can relay the tile. If it's important to you, get them to fix it, as long as you can accept the worst case scenario of the extra time (that is what we did, and then the membrane was fine anyway). Good luck.