Hi everyone, I've finally gotten around to creating a "Before and After" post which includes my kitchen and the remainder of the house. Pop on over if you'd like a look! We are very happy with the finished project. Thanks, Louise

Oh this project grows. I’m thinking the kitchen/laundry access is probably worthwhile (light, access, etc). I’m liking the more contemporary layouts, compared to the u version that I liked at an earlier date. Siriuskey your comments about that version being too wide were important. (I eventually remembered design issues with my mum’s last kitchen which was a u and too wide and while it felt spacious, it was a bit ‘not quite right’). oklouises’ wed 5.26pm (2nd option) is probably my preferred option at this stage. I think that would be functional and satisfies my wish list pretty well. Layout and furnishing the greater space is still on the go. I must say, I’ve found everyone’s input with this project so creative and helpful.

Thanks for the advice team. So the house is block work on a cement slab, but when we did our renovating in the bathroom and had to cut through and re-lay the floor in the very small bathroom we noticed that the slab was incredibly thin and had no reinforcing. The walls have some cracks however we did have the building inspected when we bought it and thought we had a solid shell to start with. (Its brick and cement we said - what can go wrong?!) Our house is not in the flood zone. There is an asbestos ceiling which has also complicated matters a little - everyone who has quoted on the job has vowed not to disturb it - but I am not sure when you are walking around up there and pulling the original roof off if this is actually possible. The roof is a flat cliplock roof with no crawl space at all, so the ceiling is on battens that are attached to the rafters. The block of land is 822 sqm and will be worth about $130 000 if the house was demolished. (Demolition is set to cost around $30 000- due to asbestos etc) We have spoken to an architect who has told us that it may be possible to reuse our kitchen, the solar set up and some windows, but if we try to force the project to reuse all of our windows and doors it could end up being counter productive. So if it happens to fit we might reuse. I just spoke to a real estate who are telling me that in our area a small new house (3 bedroom) will not reach the $300 000 value point - so it may be impossible to reach the right formula to allow the bank to lend for a rebuild-

thanks, below is the bin cabin i am looking to get its 450mm https://www.arova.com.au/collections/side-mount/products/soft-close-70l-pull-out-waste-bin-for-450mm-cainet-white the reason i put 1440 wide is that the maximum wide benchtops comes in, since it needs a joint due to the column i can cut the 3000mm stone cut in the middle and make 1500 wide of more, no problems. moving the door involved too much work like cutting bricks, door frame etc. Agree the 600mm is too deep for top cabinets, i am thinking of doing 600mm drawers with a bench then like 300-400 gap, and top cabintes at 450 or 300mm deep.